U-BOLTS WILL NOT FIT DANA 80 AXLE. 3.5 Front Lift Does Not Fit Twin I-Beam Suspension. For some F250 / F350 models, lift height may vary based on size of existing block being replaced. HD lift blocks provide a comfortable lift that will not sag over time. Includes HD Zinc plated extended U-bolts for Corrosion resistance.
State of the art powder coating with double the protection of automotive standards. Thick Heavy Metal design lasts. HOW DOES THIS LIFT KIT INSTALL ON MY VEHICLE? The rear lift block kits install simply and easily by placing the new blocks between your axle and OE leaf pack, and then securing everything together using our provided extended length U-bolts. The lift spring pack installs between your axle and factory leaf spring using again the new supplied U-bolts.DO I NEED ANY SPECIAL TOOLS FOR INSTALLATION? These kits are designed and intended to be installed using basic hand tools and should take no longer than a few hours to complete installation. We recommend the use of a Torque Wrench to ensure proper tightening of hardware. DO I NEED AN ALIGNMENT AFTER INSTALL? A wheel alignment is always recommended after any components of a vehicle's suspension have been altered.
This includes disassembly and reassembly. Having a proper wheel alignment will ensure proper vehicle control during on and off-road driving conditions, as well as help maintain even treadwear over your expensive tire investment. Heavy Metal reserves the right to make changes to the material, design, and specifications of the replacement item without prior notice. The item "For Ford F250 F350 Super Duty 1999-2004 3.5 Front + 3 Rear Lift Level Kit 4WD" is in sale since Monday, September 4, 2017.This item is in the category "eBay Motors\Parts & Accessories\Car & Truck Parts\Suspension & Steering\Lift Kits & Parts". The seller is "heavymetal-suspensions" and is located in La Mirada, California. This item can be shipped worldwide.